Raychem QuickStat Manuel d'installation télécharger pdf (Page 6)

QuickNet-RK Installation Instructions

• Cut ground jumper to length, allowing 1/2" overlap on each end

of twisted grounding wire.

• Slide SolderSleeve connectors onto ground wires and jumper.

• Heat SolderSleeve connectors until solder has melted. • Before and after re-installing the mortar and tile run the three

standard QuickNet commissioning tests from the cold lead

wire at the QuickStat Thermostat and record the results in the

commissioning log.

• Continue the QuickNet System installation following the

QuickNet and QuickStat Installation manuals.

27 28

29 30

1/2"

• Center the 4 black heat-shrinkable tubes over the installed

SolderSleeve connectors.

• Using the heat gun, shrink in place.

• Heat SolderSleeve connectors until solder and adhesive have

melted.

• Allow to cool, then repeat for second jumper wire.

1 2 3 4 5 6 7 8

Pas de commentaire

Raychem QuickStat Manuel d'installation Page 6