Raychem QuickStat Manuel d'installation télécharger pdf (Page 3)

QuickNet-RK Installation Instructions

• Remove sufficient mortar to expose 4-5 inches of heating

cable on either side of the damage. Using scissors cut the

mesh from the cable to provide room to install the splice.

9 10

• Remove at least 3 inches, and up to 5 inches of heating cable

including the damaged section leaving two protruding ends of

heating cable. If more than 5" of cable has been damaged, the

mat must be replaced.

• Remove the damaged section.

• Using the 16 AWG opening on the wire strippers carefully score

the outer jacket, 2 inches from the end of both exposed heating

cable ends.

• Flex the cable to break the insulation at the score.

• Using the high setting on the heat gun, heat the jacket to loosen

the insulation.

Score

Heating

cable

3-5"

Damaged

section

1 2 3 4 5 6 7 8

Pas de commentaire

Raychem QuickStat Manuel d'installation Page 3